SIMUFLY.COM Discussion Forums

SIMUFLY.COM Discussion Forums
https://www.simufly.com/cgi-bin/yabb2/YaBB.pl
Delco Carousel IV-A INS For Microsoft Flight Simulator >> Delco Carousel IV-A INS For Microsoft Flight Simulator >> INS heatup problem
https://www.simufly.com/cgi-bin/yabb2/YaBB.pl?num=1279386092

Message started by Benedettini on Jul 17^th, 2010, 6:01pm

Title: INS heatup problem
Post by Benedettini on Jul 17^th, 2010, 6:01pm

I switch to STBY,and put my Position coordinates,
Then,switch to Align to align the INS system,heating up
Goes from 95 to 85...75...65. At 65,it stucks,and Red WARNlight lightens up.
When plane is ready for taxiing (engines on,systems working)
For making INSNAV light comin up,i need minimum 55. How to do this now?

Title: Re: INS heatup problem
Post by vololiberista on Jul 17^th, 2010, 7:49pm

When you enter you POS coordinates make sure you only press <insert> once after inserting your latitude. It's a common mistake as <insert> stays lit so it makes one believe that it isn't working hence a second press at least. For a very long time I couldn't get pass 6 9 for this reason and only on this forum was I told to be careful.
vololiberista

Title: Re: INS heatup problem
Post by Gianfranco Corrias on Jul 19^th, 2010, 5:20pm

When the WARN red light comes on you have to perform the related ABNORMAL procedure.You have to set the CDU selectors to DSRTK/STS and read the codes and you have to apply the related procedure as written in the operations manual.
Gianfranco